Table of Contents
Advertisement
Operating instructions LITTY 4you
Operating instructions LITTY 4you
Once the position of the back shell has been
Once the position of the back shell has been
set, tighten the M5 fixing screws (AF 3 mm)
set, tighten the M5 fixing screws (AF 3 mm)
using 4 Nm torque again. The associated nuts
using 4 Nm torque again. The associated nuts
(AF 5mm) must be tightened for this.
(AF 5mm) must be tightened for this.
Please note that if you move the back shell
ease note that if you move the back shell
further back, this will move the centre of gravity
further back, this will move the centre of gravity
further back which makes it easier to tip the
further back which makes it easier to tip the
product up (Chapter 16.6).
16.3 Adjusting seat width
To widen the product, widening sets can be
To widen the product, widening sets can be
ordered which are may up of an axle tube, seat
plate, back shell and back cross bar as well as
plate, back shell and back cross bar as well as
footrest support tubes or foot plate in a corr
footrest support tubes or foot plate in a corre-
sponding size.
Back cross bar
Back cross bar
Axle tube
Figure 6: Back cross bar and axle bar, view of pro
: Back cross bar and axle bar, view of prod-
uct from rear
Contact your specialist retailer if you want to
Contact your specialist retailer if you want to
change the width of the seat.
16.4 Adjusting the seat depth
Adjusting the seat depth
To adjust the seat depth to suit body dime
To adjust the seat depth to suit body dimen-
sions, the distance between the seat plate and
sions, the distance between the seat plate and
back shell can be infinitely adjusted. The a
back shell can be infinitely adjusted. The ad-
justment is made by undoing the
justment is made by undoing the two M6 fixing
screws (AF 4 mm) on each side in the
points.
of an axle tube, seat
in the rotation
M6 fixing screws
M6 fixing screws
Figure 7: Fixing screws on the seat plate in the
Fixing screws on the seat plate in the
rotation points
Afterwards, the seat plate is
Afterwards, the seat plate is shifted along the
slots on the fixing screws.
Figure 8: Possible directions of movement of the
: Possible directions of movement of the
seat plate with slots
Afterwards, tighten the M6 fixing screws (AF 4
Afterwards, tighten the M6 fixing screws (AF 4
mm) on the rotation points again using 7 Nm
mm) on the rotation points again using 7 Nm
torque.
After adjusting the seat plate, it may be nece
adjusting the seat plate, it may be neces-
sary to adjust the position of the back shell.
sary to adjust the position of the back shell.
Please pay attention to the advice in Chapter
Please pay attention to the advice in Chapter
16.2.
16.5 Adjusting the lower leg length
Adjusting the lower leg length
adjusting the footrest
adjusting the footrest
The footrest support tubes are clamped on the
The footrest support tubes are clamped on the
left and right onto the lower frame tubes into
onto the lower frame tubes into
the foot bracket clamps. The foot bracket
the foot bracket clamps. The foot bracket
clamps are secured against twisting through
clamps are secured against twisting through
interlocking serration.
10
Advertisement
Table of Contents
