Final Check List - Scotsman C0522R Installation Manual

heavier. Ground wire must be green/yellow color.
Only one cord per plug.
5. Install a field supplied, non-detachable,
non-metallic strain relief per code.
6. Route the power cord through the access hole /
strain relief and properly attach the power supply
wires. Do not tin the leads. Strip 6 mm of power
cord lead insulation and properly attach power cord
wires to the lead wires in the junction box.
7. Connect an electrical plug of the proper type for
the application and country of use.
8. Attach a ground wire to the ground connection in
the junction box. Note: Ground wire must be longer
than power lead wires.
9. Reconnect power supply. Check voltage when
complete.
Return the junction box cover to its original position
and secure with the original screws.
Remote Condenser Models - Installation Manual

Final Check List:

1. Is the unit located indoors in a controlled
environment?
2. Is the condenser located where it can receive
adequate cooling air?
3. Has the correct electrical power been supplied
to the machine?
4. Have all the water supply connections been
made?
5. Have all the drain connections been made?
6. Has the remote condenser been properly
installed?
7. Has the interconnecting tubing been properly
routed between the remote condenser and the
ice machine?
8. Have the quick connects been properly
connected?
9. Has the power supply wire from the ice
machine to the remote condenser been
properly run and connected?
10. Has the unit been leveled?
11. Have all unpacking materials been removed?
12. Is the water pressure adequate?
13. Have the drain connections been checked for
leaks?
14. Has the bin interior been wiped clean or
sanitized?
15. Have any water filter cartridges been replaced?
16. Have all required kits and adapters been
properly installed?
June 2007
Page 15
C0522 through C1030