Advertisement
Available languages
Available languages
Levelling
To level the refrigerator use the two levelling screws found on the base at
the front. Make sure that the refrigerator is placed on level ground. Adjust
the levelling screws to ensure that the refrigerator doesn't move during
day-to-day use.
Turn the screws anti-clockwise to lift the front of the refrigerator and
clockwise to lower it.
The front part of the refrigerator should be a little higher than the back
causing it to tilt backwards slightly. Levelling requires two people; one to
tilt the unit backwards and the other to turn the screws.
To level it, lift the front by turning the screws until there is a 48 mm (1.9
in) gap between the floor and the base of the refrigerator, as indicated in
the figure on the right.
Observe the following when installing:
IMPORTANT– AFTER LEAVING THE REFRIGERATOR TO STAND 6 TO 8 HOURS
And before plugging it in:
1.-
Clean the interior of your refrigerator with a cloth or soft sponge, and a neutral soap
or a bicarbonate of soda solution.
2.-
Plug it in to the correct outlet.
3.-
Leave it on, empty and closed, for 4 hours before putting food inside.
4.-
Avoid opening the door before optimum temperature has been reached.
5.-
If you want to move your refrigerator to another location, disconnect it.
When it has been repositioned repeat steps 3 and 4.
CAUTION
In the case of physical, mental or sensorial difficulties (including children), or if you
don't have sufficient experience or knowledge to handle this product, you will need
the assistance of a capable adult to ensure safety.
Children should always be supervised. This product is not a toy.
Minimum Electrical Requirements:
Check the voltage and frequency characteristics in accordance with your country of residence.
Country
Nominal Characteristics
Mexico
115 V ~ 60 Hz
Brazil
127 V ~ 60 Hz / 220 V ~ 60 Hz
Europe
220 V - 240 V ~ 50 Hz
Middle East
220 V - 50 Hz / 110 V ~ 60 Hz
Peru
220 V ~ 60 Hz
Ecuador
115 V ~ 60 Hz
Venezuela
115 V ~ 60 Hz
Colombia
115 V ~ 60 Hz
Chile
220 V ~ 50 Hz
El Salvador
115 V ~ 60 Hz
Argentina
220 V ~ 50 Hz
Canada
115 V ~ 60 Hz
8
Levelling
Front
Back
Screws
Wheels
Wheels
Front
Front
48 mm
Levelling
Front
Screws
Wheels
Back
Wheels
Advertisement
