Recommended Support Equipment - PSC 2000781J MkII MLB Operating Procedure

15. Recommended Support Equipment

The following is a list of equipment PSC has developed over years of Lightband operation and training. This
equipment is not required for proper Lightband operation but is very useful. PSC does not supply any of the items
listed below. See PSC's website to download drawings of these parts.
Tip Step
1 7.1.2 On the MLB 15.000-24 PSC uses 0.25-28 SHC screws
7.1.6 with the head diameter reduced. This eliminates the
interference fit described in step 7.1.6.
Part: 4000845 Reduced Head SHC Screw
2 8.1.1 PSC uses custom aluminum transition rings as
adjoining structures for all Lightband operations and
testing. They provide the necessary stiffness to
operate the Lightband and ease attachment to other
structures.
Part: 2000741 Transition Ring
3 8.1.11 Use of a go/no-go gauge simplifies verification of the
Lightband's pre-stow height.
Part: 2002486 MLB Go No Go Stow Gauge
4 10.1.10 PSC occasionally uses custom guide rods (Deploy
Upper Ring Stops) to restrain the Upper Ring during
separation. They stop the Upper Ring at full Separation
Spring extension. This is helpful if immediate
separation is desired after deployment.
Part: 2000843 Deploy Upper Ring Stop
5 7.1.5 PSC ensures circularity of Lower and Upper Rings by
7.1.8 aligning to adjoining structures with custom flat head
screws. They are 82° flat head screws with the head
diameter reduced to fit between Leaves.
Part: 2002753 FLH Alignment Screw
PSC Proprietary
Table 15-1: Support equipment
Best Practice / Lesson Learned
2000781J MkII MLB Operating Procedure
Image
Page 44 of 50