Table of Contents
Advertisement
Installing the stove
The floor on which the stove is installed must be even and
horizontal. The stove may only be installed on an adequate
load-bearing floor. The stove can be stood on a metal floor
and
sheet or glass sheet to protect the flooring.
2.0 INSTALLATION INSTRUCTIONS
If the flooring or carpet is inflammable, a stable and non-
uate
combustible spark protection plate must be used. This
floor
must extend 50 cm to the front and 30 cm to each side
beyond the edge of the combustion chamber opening.
2.3 - Positioning the Appliance
Under the stove no spark protection plate is required.
The technical data sheet and the type of board on the stove contain the data referring to the stove that
non-
might differ from these standard regulations.
This
Assembly sequence
side
In case of combustible floors, being sensitive to a rise in temperature, non combustible floor protectors
● If intended, install the OEC.
must be used. This floor protector must reach 50cm beyond the front of the stove, 30cm to either side
● The Ø150mm stovepipe connection can be installed at
ing.
the top or rear. The stove is supplied ready for connec-
(measured form inside the combustion chamber). The floor protector can be made of metal or glass. The
tion from above. If you wish to connect it at the rear, the
given minimum distances from combustible or heat sensitive materials have to be kept by all means at the
following steps must be carried out to make the neces-
back, the front and sides.
sary modifications:
- Break out the cover in the back panel.
Certain stoves can be installed without safety distances, which can be found on the technical data sheet
- Replace the connector sleeve and the sealing cover.
and the type of board.
● Decide where the stove is to be installed. There must be
no objects made of combustible materials within a dis-
More information regarding min. safety distances from the connecting pipe can be found at the description
tance of 80 cm of the stove's radiation area, measured
d at
of the connection.
from the combustion chamber's inspection glass, nor
nec-
may any be placed within this area subsequently.
Depending on the installation position of the stove in
the
front of walls that need to be protected (flammable or
ces-
load-bearing), the following distances from walls need
to be observed in accordance with the position of the
Stove Installation straight in corner
combustion chamber door to the wall / side panel or
the back panel (see schematic diagram).
When not dealing with walls that need to be protect-
er.
ed, you merely need to observe a minimum distance of
approx. 5 cm to allow for proper heat dissipation.
● Install the pipe lining (provided on site) in the chimney.
t be
The connection height can be individually specified for
dis-
a top stovepipe connection, however should not exceed
1.5 m from the connector sleeve. For the rear stovepipe
ured
connection heights please refer the "Technical Data"
nor
chapter. No combustible material is permitted within a
radius of 20 cm around the stove pipe.
25
● Connect the stovepipe at both connection points with
e in
stove putty so that the stove pipe is permanently sealed.
● Push the stove onto its planned position and orient it so
e or
that the stovepipe fits into the pipe lining.
eed
The stovepipe connections must be tight. The stove-
the
pipe must not protrude into the chimney.
Stove installed straight in corner
el or
Bear in mind that on partition walls in accordance with
test specification EN 13240 the temperature of 85°C
can be reached, and with light wallpaper or similar
ect-
combustible construction materials this can result in
colour changes.
e of
The flue connections must be tight. The stove- pipe must not protrude into the chimney. Bear in mind that
on partition walls in accordance with test specification EN 13240 the temperature of 85°C can be reached,
ney.
and with light wallpaper or similar combustible construction materials this can result in colour changes.
d for
eed
pipe
10
ata"
in a
with
25
Stove installed straight in corner
Stove Installation diagonally in corner
10
25
Dimensions in cm
Stove installed diagonally in corner
PAGE 8
25
Dimensions in cm
Dimensions in cm
15
Advertisement
Table of Contents
