Page 3
Viewing of measurements – – IN = – LO = Lowest peak – HI = – AV = Average value – – MD = Maximum Demand - – – – – Doc:I411RUGB11_20.doc 16/11/2020 p. 3 / 20...
Page 4
Table of display pages Selection with Selection with SUB- -TO- LO AV -TO- LO AV LO AV MD LO AV MD LO AV MD LO AV MD LO AV LO AV LO AV LO AV LO AV LO AV LO AV THD- THD- 14 VLL HARMONICS...
Page 5
Display pages navigation Phase–Phase voltages Phase–Neutral voltages Phase and Neutral currents … … Indication of energy meters Imported active Energy energy Indication of hour meter Doc:I411RUGB11_20.doc 16/11/2020 p. 5 / 20...
Page 6
– Indication of harmonic analysis FUNCTION Doc:I411RUGB11_20.doc 16/11/2020 p. 6 / 20...
Page 7
IR programming port -W - CX02 CX01 Doc:I411RUGB11_20.doc 16/11/2020 p. 7 / 20...
Page 8
Main menu o SET - o SET – o CMD - o CMD – o PAS - o PAS – o I-O - o I-O – P.01 .01, P.02, P.03 P.01, P.02, P.03… Doc:I411RUGB11_20.doc 16/11/2020 p. 8 / 20...
Page 9
M N D U menu Doc:I411RUGB11_20.doc 16/11/2020 p. 9 / 20...
Page 13
P11 – P11 – Default Range Note: this menu is Default Range P13 – P13 – INPUTS – – – – – – OFF – OFF – ON – ON – LOCK – – LOCK – – – C01…C08 – C01…C08 –...
Page 14
Commands menu COMMAND Wiring test Doc:I411RUGB11_20.doc 16/11/2020 p. 14 / 20...
Page 15
COD COMMAND SETUP DEVICE CX02 SETUP DEVICE CX02 SETUP CX02 DEVICE SETUP CX02 DEVICE CLONE DEVICE CX02 CLONE DEVICE CX02 CLONE CX02 DEVICE CLONE CX02 DEVICE INFO DATA CX02 INFO DATA CX02 EXIT EXIT Doc:I411RUGB11_20.doc 16/11/2020 p. 15 / 20...
Page 16
Installation Doc:I411RUGB11_20.doc 16/11/2020 p. 16 / 20...
Page 17
Wiring diagrams 3-phase connection whit or without neutral 2-phase connection -L2-L3-N L1-L2-L3 -N-L2 Single-phase connection Balanced 3-phase connection whit or without neutral -L2-L3-N-BIL L1-L2-L3-BIL ARON 3- ARON connection 3-phase without neutral ARON connection 3-phase without neutral -L2-L3 -L2-L3 3 phase connection with neutral via VT 3 phase connection without neutral via VT –...
Page 18
RS485 PC- DMG610 connection through RS485 interface - Remote control Order code Description Wt [kg] Terminals position DMG600 DMG610 Doc:I411RUGB11_20.doc 16/11/2020 p. 18 / 20...