Pci Hardware Failure - Chrysler Pacifica 2004 Manual

BRAKES (CAB)
Symptom:

PCI HARDWARE FAILURE

When Monitored and Set Condition:
PCI HARDWARE FAILURE
When Monitored: Ignition On - Continuously
Set Condition: When the CAB detects an initilization or configuration failure that doesn't
match the programmed parameters.
INTERMITTENT DTC
DAMAGED CAB/CAB HARNESS CONNECTOR
FUSED RUN RELAY OUTPUT CIRCUIT OPEN
ABS VALVE FUSED B(+) CIRCUIT OPEN
ABS PUMP FUSED B(+) CIRCUIT OPEN
CAB - GROUND CIRCUIT OPEN
CAB - INTERNAL FAULT
TEST
1 Turn the ignition on.
With the DRBIII , read DTCs.
With the DRBIII , erase DTCs.
Turn the ignition off.
Turn the ignition on.
With the DRBIII , read DTCs.
Does the DRBIII display PCI HARDWARE FAILURE?
Yes → Go To 2
→ Go To 7
No
2 Turn the ignition off.
Disconnect the CAB harness connector.
Inspect the CAB/CAB harness connector for damage.
Is there any broken, bent, pushed out, corroded or spread terminals?
Yes → Repair as necessary.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Perform ABS VERIFICATION TEST - VER 1.
38
APPLICABILITY
All
All