Chrysler Pacifica 2004 Manual page 31

PCI BUS COMMUNICATION FAULT —
TEST
9 Turn the ignition off.
Disconnect the CAB harness connector.
Measure the resistance of the PCI Bus circuit between the CAB harness connector
and the Data Link connector.
Is the resistance over 5.0 ohms?
Yes → Repair the PCI Bus circuit for an open.
→ Replace the Controller Antilock Brake in accordance with the
No
10 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Perform ABS VERIFICATION TEST - VER 1.
Service Information.
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
Continued
29
BRAKES (CAB)
APPLICABILITY
All
All