Advertisement
Installation
11
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws
with washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers
(not included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors,
followed by #12 x 3 in. screws (not included).
12
DRILL HARDWARE IN DOOR
□ Using a clamp, place a scrap piece of wood on the face of the door
and tighten to hold in place, taking care not to damage the face of
the door. Use a drill with a 5/16" bit to finish drilling a hole in the
exsiting pilot hole.
13
INSTALLING THE HARDWARE
□ Attach the knobs (AA) to the cabinet with the provided screws (BB).
14
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber's putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer's instructions.
□ Apply silicone caulk/sealant (not included) to all four corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal amount of overhang on each side
and use a level to ensure the vanity top surface is level.
□ Apply silicone onto the seam between the edge of the vanity top and the
wall, smooth the bead, and allow to cure before use.
NOTE: Matching side and back splashes available, sold separately.
□
To purchase, visit your local Home Depot store or go to homedepot.com.
BB
Please contact 1-888-774-8062 for further assistance.
AA
HOMEDEPOT.COM
Advertisement
