Home Decorators Collection PPCOPDRF30M Use And Care Manual

TOOLS REQUIRED
Hammer Safety goggles
Measuring tape Wall hardware
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
□ Determine the desired mounting location, and mark the
wall where the unit will be installed.
NOTE: For secure installation, the unit must be mounted
to at least one wall stud.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with washers
into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate locations
and insert toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the appropriate
locations and insert #12 wall anchors, followed by #12 x 3 in.
screws (not included).
4
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber's putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer's instructions.
□ Apply silicone caulk/sealant (not included) to all four
corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal amount of
overhang on each side and use a level to ensure the
vanity top surface is level.
□ Apply silicone onto the seam between the edge of
the vanity top and the wall, smooth the bead, and
allow to cure before use.
Use and
Care Guide
Vanity Combo
Phillips screwdriver Power drill
Caulk/sealant
Model# PPCOPDRF30M
HARDWARE INCLUDED
AA - Handle x 2
CC - Hanging Bracket x 2
Level
2
POSITIONING THE CABINET
□ Move the cabinet into place,
and use wood shims to level the
cabinet against the wall.
5
INSTALLING THE HARDWARE
□ Attach the handles (AA) to the cabinet
with the provided screws (BB).
Please contact 1-888-774-8062 for further assistance.
Item# 1004 671 480
BB - Handle Screw x 4
DD - Screw x 4
BB
AA
HOMEDEPOT.COM