Home Decorators Collection PPLNKDCG48D Use And Care Manual

TOOLS REQUIRED
Hammer Safety goggles
Measuring tape Wall hardware
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present. Compare parts with
the Hardware Included list. If any part is missing or damaged, do not attempt to
install the product.
□ Determine the desired mounting location, and mark the wall where the unit
will be installed.
NOTE: For secure installation, the unit must be mounted to at least one wall stud.
2
CUTTING THE OPENING FOR PLUMBING FIXTURES
NOTE: This step applies to vanity cabinets with full back panels only.
□ Locate and mark plumbing on the back panel.
□ Drill a pilot hole through the back panel.
□ Use a keyhole saw to cut an opening for the plumbing fixtures.
3
POSITIONING THE CABINET
□ Move the cabinet into place,
and use wood shims to level the
cabinet against the wall.
Use and Care Guide
Vanity Combo
Phillips screwdriver Power drill
Caulk/sealant Keyhole saw
HARDWARE INCLUDED
AA - Knob x 4
Level CC - Long Screw x 2
4
BEFORE BEGINNING ASSEMBLY
□ Read directions thoroughly
□ Decide on right or left hand door configuration
□ Perform door / drawer swap prior to vanity installation.
Item # 1003 619 899
Item # 1003 619 903
Item # 1003 619 904
Model #PPLNKDCG48D
Model #PPLNKDVR48D
Model #PPLNKWHT48D
BB - Short Screw x 2
HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.