Static And Dynamic Content - MediaFORM Director Series Operator's Manual

• Double left-click the "Local Resources" selection to list drives available
within the DIRECTOR or double click the "Network Neighborhood"
selection to list drives available in your network workgroup.
• Click the source drive you require.
• Click the OK button. You will be returned to the Image tab screen.

Static And Dynamic Content

The DIRECTOR allows CDs to be created from both static and dynamic
content. A finished CD created from static content will contain the exact
files and folders that are specified when the disc image is created. A
finished CD created from dynamic content will contain the files and folders
that exist in specified locations at the time the job is submitted for recording
(rather than when the disc image is created).
For example, specifying dynamic content when creating a CD layout would
allow a job to be run every week that records the contents of a specific
folder onto a CD without having to create a new disc image every time. In
this case the contents of the folder (not the folder itself) can change.
To specify a file or folder on a disc image as containing dynamic content:
• Click the *.* check box so that it is checked.
Note: Please be sure not to exceed the capacity of the disc being used.
DIRECTOR Series Operator's Guide
Page 56
Document Revision: 0802