Installing The Printer Support; Attaching The Pds (Printer Docking Station) To The Director - MediaFORM Director Series Operator's Manual

Installing The Printer Support

The printer support bracket must be installed before the printer may be installed. The
bracket attaches with three fasteners and extends from the back of the unit as depicted
below.

Attaching The PDS (printer docking station) To The DIRECTOR

• Loosen the screws from the back of the unit about half way, if already in
place. Align the slots of the bracket with the mounting screws on the
rear of the unit. Slide the bracket down over the mounting screws.
Fasten the bracket in place by tightening the screws clock-wise.
DIRECTOR Series Operator's Guide
Page 18
Document Revision: 0802