Table of Contents
Advertisement
US-EN
Installation and operation instructions
7.1.3. Replacing control unit
If your control unit is not working properly, contact BEKO TECHNOLOGIES GmbH or one of its agents. Have the serial
number printed on the name plate handy.
If an exchange of the control unit is required as a result of assessing the situation, then you will receive the installation
instructions with the new control unit.
7.1.4. Replacing float drain
If the float drain is defective, it must be replaced.
1. Close the shut-off valves (1) and open the shut-off valve (2) of the bypass.
2. Hold the top part of the housing, unscrew the housing extension (3) and remove it (4).
2
1
1
3
4
For detailed instructions for the replacement of the float drain, refer to the instruction sheet shipped with the spare part.
DRYPOINT
M intelligence
29
®
Advertisement
Table of Contents
