Table of Contents
Advertisement
Technical description
11.12 DMC51 electronic control unit
K
Set
DISPLAY
The DMC51 controls all the operations, alarms and dryer operation set-up.
11.12.1 Switching the dryer on
Connect the dryer to the electric mains and switch it on via the ON/OFF switch (pos. 1 Section 11.1).
During normal operation, the display shows the dew point temperature.
11.12.2 Switching the dryer off
Switch the device off via the ON/OFF switch (pos. 1 Section 11.1).
11.12.3 Indication of the operating parameters
During normal operation, the display shows the dew point temperature (in °C or °F).
Led
shows that the compressor is ON.
Press the
Set
button and keep it pressed to display the compressor discharge temperature (probe T2 if installed).
Press the
button and keep it pressed to display the hours remaining until the next maintenance.
Press the
Set
+
hours of the dryer (ie when dryer is powered)
Press the
button and keep it pressed to display the % of energy saved.
Note:
The temperatures are indicated in °C or °F (LED
The total operating hours and the hours until the next maintenance are indicated in the field 0...999 hours,
and in thousand hours from 1.0 hours onwards (example: when the display shows 35, this means 35 hours
and when the display shows 3.5, this means 3,500 hours).
The % of energy saved is calculated considering the running hours of the compressor against the operating
hours of the dryer (example: during 10 hours of powered dryer, compressor has ran for 4 hours, display
shows 60% of energy saved).
24
reset
buttons simultaneously and keep them pressed to display the total number of operating
Led - temperature in °C
Led - temperature in °F
Led - compressor ON
Led – Alarm
Led - service warning
Button – access configuration menu /
Set
Discharge temp.
Button – decrease / service
Button – increase / % energy saved
or
is on).
DRYPOINT® RA CT 200-500 NA 3PH
Advertisement
Table of Contents
Troubleshooting
