Page 1
R460 KEG SCALE USER MANUAL www.charder.com Please read this manual carefully before operating the device and keep it at hand for future reference.
R460 Keg Scale INTRODUCTION This user manual will guide you through the correct operating procedure for the R460 Keg Scale, please read this manual thoroughly before operation and keep it at hand for future reference. R460 Keg Scale Maximum Weight Capacity: 200kg.
The original purchaser of the product must have proof of purchase to receive warranty service. Please keep your invoice or receipt. Charder authorized dealers or retail stores selling Charder products do not have the right to alter or modify or in any way change the terms and conditions of this warranty.
R460 Keg Scale PACKAGING What’s in The Box: Scale Platform x1 Remote Display x1 Display Cable x1 Wall Mount Bracket Set x1 Power AC Adapter x1 User Manual x1 Before Started: Ö Make sure the display cable is attached firmly on both sides.
R460 Keg Scale INSTALLATION Power Supply There are two types of power supply for this scale: Power Adapter (Included) & 4-AA Batteries (Not Included). 1. Power Adapter: To apply power to the scale using the supplied 15V DC power supply, insert the plug from the power supply cable into the power jack on the left side of the indicator, and then plug power supply into proper electrical outlet.
Page 7
R460 Keg Scale Get Started: 1. Plug display cable into bottom of display. 2. Plug the other side of display cable into the bottom of platform, flatten the cable as shown. Optional: Bracket Mount Installation Without Bracket via Magnetic Joint: Magnetic joint behind at the back of the display can attach to any metal surface without installing bracket mount.
Page 8
R460 Keg Scale With Bracket via Wall Screw: 1. Locate position on wall for display mounting bracket, mark and drill holes. 2. Insert plastic tip screws (included) into drilled holes. 3. Screw in with screw drivers and tighten to secure mounting bracket to wall 4.
R460 Keg Scale OPERATION Display: A. kg / lb / lb oz This indicator will be turned on to indicate that the displayed weight is in kg/lb/lb oz. B. Stability Indicator This indicator will be turned on when the weight display is stable.
R460 Keg Scale ERROR MESSAGES Replace with new Low battery. batteries Overloaded. Remove extra weight. Display cable not Reconnect cable. connected. Remove weight before Zero value too high. turning on. Calibration mode enter Contact local Charder failure. Service Retailer. TROUBLESHOOT...
R460 Keg Scale SETTINGS CONFIGURATION 1. Changing the default measuring unit (kg & lb). (Default: kg) While scale is on, press TARE key for 6 seconds to enter setting. At this time, display shows “SET”, followed up by “UNIT”. a. Press TARE to enter setting mode “UNIT”.
R460 Keg Scale SETTINGS CONFIGURATION Turn on the scale, hold TARE button for 6 seconds. Press TARE to confirm each selection. lb oz [Default Measure Unit] [Auto Turn Off Time] [Beep Sound Toggle] [Backlight Toggle] FOR DISTRIBUTOR AND SERVICE PERSONNEL USE ONLY...
R460 Keg Scale SCALE CALIBRATION This scale has been factory calibrated and does not require calibration prior to use. If required, the scale can be calibrated. The following procedure assumes the scale is set to kg weighing unit and the default calibration weight is 100kg.
Need help?
Do you have a question about the R460 and is the answer not in the manual?
Questions and answers