TVS staR city+ User Manual page 62

REAR WHEEL REMOVAL AND REASSEMBLY
1. Remove the rear brake adjuster nut (1) and
disconnect the brake rod.
2. Remove the split pin (2) and the nut (3) from
torque link mounting with the brake panel and
disconnect the torque link.
3. Remove the axle nut (4).
4. Pull out the axle (5) and take out the spacer bush
from the rear wheel assembly.
5. Tilt the vehicle to the left and take out the wheel
along with the brake panel. Separate the brake
panel from the wheel.
4
1
2
3
52
6. For locating and reassembling the rear wheel
7 . Reverse the procedure for reassembly.
Once the split pins are removed, replace them with new
ones.
Always make sure that whenever the wheel is removed,
axle nut is properly re-tightened to the specified torque.
5
easily, engage the gear. This will arrest the free
movement of the drum sprocket.
Caution
Warning