Selection Of Installation Equipment - Candy CIS633MCTT Instruction Manual

Installation

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by the
heat radiation from the hotplate. As shown below:
L(mm) W(mm)
590 520
Under any circumstances, make sure the Induction cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the Induction cooker hob is in
good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above
the hotplate should be at least 760mm.
A(mm) B(mm)
760 50 mini
H(mm) D(mm)
55 51
C(mm) D
20 mini Air intake
A(mm) B(mm)
560 490
E
Air exit 5mm
EN-25
X(mm)
50 mini