Tutorial 5 - Using The Trajectory Step - Microscan Visionscape GigE Getting Started

Tutorial 5 — Using the Trajectory Step
FrontRunner™ Job:
Start > Visionscape > Visionscape Tutorials & Samples > Tutorials >
GigE Systems > Using the Trajectory Step > tutorial_trajectory.avp
This tutorial shows you how to use the Trajectory Step to inspect a grid of
parts.
Start FrontRunner™ by selecting Start > Visionscape > Visionscape
1.
FrontRunner. FrontRunner™ displays its main window.
Select a Visionscape
2.
Start creating a new Job by clicking
3.
To display the Job Tree and Step Tree Editor, click
4.
This allows you to view your Job as you create it.
Note: Maximize or minimize the Editor as needed to accomplish the
steps in this procedure.
Highlight Acquire in the Step Tree (left pane). FrontRunner™ displays
5.
the Acquire properties page.
Note: You may have to click the Acquire tab in the properties window.
Adjust the following settings:
6.
–
–
Getting Started with Visionscape GigE Cameras
®
Device on the FrontRunner Device toolbar.
Picture Mode — Set to Load Images from File.
File List — Click <empty>, and then Add... This displays the
Open window. Browse for the file TrajectoryTutorial.tif from
Windows. It is located at: C:\Vscape\Tutorials &
Samples\Tutorials\GigE Systems\Using the Trajectory Step\.
Select TrajectoryTutorial.tif and click Open. This will load the file
and its path into the File List.
Note: This file was installed on your
hard drive when you installed Visionscape
Tutorial 5 — Using the Trajectory Step
.
®
. If you installed
3
.
3-43