Ip Configuration; Setting The Ip Mode; Setting The Ip Address Using Commands - Atlona AT-OPUS-RX41 Manual

4x1 4k hdr switcher and receiver with hdmi and hdbaset inputs

Table of Contents

The AT-OPUS-RX41 is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available),

will automatically assign an IP address to the unit. Use an IP scanner, along with the MAC address on the back of

the unit, to identify both the unit and its IP address on the network. If a static IP address is desired, the unit can be

switched to static IP mode. Use one of the following procedures to switch between DHCP and static IP mode. The

default static IP address of the AT-OPUS-RX41 is 192.168.1.254.

If the AT-OPUS-RX41 is unable to detect a DHCP server within 15 seconds, then the unit will set all IP settings to

zero.

Setting the IP Mode

1. Make sure the AT-OPUS-RX41 is powered.

2. Connect an Ethernet cable between the LAN port of the AT-OPUS-RX41 and the Local Area Network (LAN).

OPUS

3. Press and hold the INPUT button on the front panel for approximately 20 seconds. Release the INPUT button

once the POWER button begins to flash blue and red. The number of flashes will indicate the currently selected

IP mode.

POWER button flashes

Two

Four

Setting the IP Address Using Commands

Use the IPStatic and IPDHCP commands to switch between DHCP and IP mode through RS-232 or Telnet. Refer to

API documentation for more information. All commands and their arguments are case-sensitive.

•

Setting static IP mode

1. Connect to the AT-OPUS-RX41 using RS-232 or Telnet.

2. At the command line, execute the IPDHCP command using the off argument, as shown.

IPDHCP off

AT-OPUS-RX41