Table of Contents
Advertisement
Set up
Function
Group
Prompt
Top Display
LATCH
SEL
BLOCK
TIMER
START
Revision 2.0
July 2015
7-Segment
Default
Code
Value
Upper Display
LATCH
LACH
NoLATCH
BLK
DISABLE
TMR
Disable
STAT
KEY
EDC201 / EDC202 / EDC203 Product Manual
Selection or
7-Segment
Range of
Code
Setting
Lower Display
Yes/ No
DISB
DISABLE
ALM1
ALARM1
ALM2
ALARM2
AM12
ALARM12
DISB
DISABLE
EABL
ENABLE
KEY
KEY
3. Configuration
3.7. ALARM Set Up Group
Parameter
Definition
Alarm output is
configured to be
Latching.
When the alarm
condition disappears,
an acknowledge signal
is needed to reset the
alarm status.
Alarm output is
configured to be Non-
latching.
When an alarm
condition is met, the
alarm is triggered;
when the alarm
condition is cleared,
the alarm is
automatically reset.
Disables alarm
blocking
Blocks Alarm 1 only.
Blocks Alarm 2 only.
This configuration is
not available on
EDC201.
Blocks both alarms.
This configuration is
not available on
EDC201.
Disable the timer.
Enable the timer.
START allows you to
select whether the
timer starts with the
keyboard (A/M OK
key). This
configuration is not
available on EDC201.
35
Advertisement
Table of Contents
