Greasing Transporter Lead Screw Unit And Transporter Motor Unit Assembly Gear Mechanism Unit - Konica Minolta REGIUS 110 Service Manual

Chapter 7 Periodic Maintenance
7.2.8 Greasing Transporter Lead Screw Unit and Transporter Motor Unit
Assembly Gear Mechanism Unit
Apply grease to the transporter lead screw unit and the transporter motor unit assembly gear mechanism
unit.
Be sure to turn OFF the power supply circuit breaker and unplug the power cable from the
equipment whenever the maintenance is performed.
Caution
First Front Back Side
Transporter Lead
Screw Unit
This completes the greasing the transporter lead screw unit and the transporter motor unit assembly fear
mechanism unit.
Go to "7.2.9 Greasing of Release Shaft Holder (Page 7-13)"
7-12
1
2
3
Transporter Motor
Unit Assembly
Gear Mechanism
4
Move the optical unit to the second front back
side.
It is necessary to move the optical unit to the
second front back side when moving the push
Note
plate unit of the transporter unit (procedure to
turn the transporter lead screw).
Remove the exterior frame (back).
•
9 screws (M4 x 8)
Apply grease to the transporter lead screw unit
and the transporter motor unit assembly gear
mechanism unit.
•
Grease: Plusguard No. 2 by Kyodo Yushi
Always use the specified grease.
Important
Apply grease on entire area by turning the transporter
lead screw by a screw driver.
Attach the exterior frame (back).
•
9 screws (M4 x 8)
and apply grease to the release shaft holder.