Table of Contents
Advertisement
Operating the appliance
en
Starting the programme
Touch and hold I button for 1~2
seconds, then release the button. The
programme starts and the appliance
door is locked.
The finish-in time is shown in the display
panel and counts down until the
programme starts. After the programme
has started, the programme duration is
displayed. And the symbols for the
programme progress are lighting up.
Note:
Foam detection
If the symbol o also lights up in the
display panel, the appliance has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Childproof lock
You can lock the appliance to prevent
the functions you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the w 3 sec button for 3 seconds.
w 3 sec lights up: The childproof
■
lock is activated.
w 3 sec flashes: If the programme
■
and programme settings are
adjusted while childproof lock is
activated.
When the programme ends, End
Note:
is displayed. The door is unlocked. w
3 sec remain on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch and hold the w 3 sec button
until the w 3 sec indicator lamp is off.
44
Adding/removing laundry
After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the I button. The appliance
checks whether reloading is possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
I button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the I button.
1.
Select another programme.
2.
And touch the I button again. The
3.
new programme starts from the
beginning.
If drying is activated, you have to
Note:
switch the appliance off and on again to
change the drying programme.
Advertisement
Table of Contents
