Summary of Contents for Z Corporation SPECTRUM Z M510
Page 1
UICK TART UIDE FOR 510 3D P PECTRUM RINTER HIS GUIDE PROVIDES YOU WITH AN OVERVIEW PART REMOVAL PART POST PROCESSING STEPS REQUIRED PRINT A PART OR A DETAILED STEP STEP GUIDE TO RINTER PLEASE REFER TO THE PECTRUM USER MANUAL OR VISIT THE EBSITE ZCORP USERS...
Page 2
3D P REPARING THE RINTER 1. Fill feed box with powder. 2. With the printer offline, spread powder over build area by pressing the ‘Spread’ button on the control button for four spreads. printer will then automatically spread powder over the build area.
Page 3
5. Check wash fluid and waste fluid. Fill wash fluid and dispose of waste fluid. 6. Put printer online pressing ‘Online’ button on the control panel. Technical Tip - LEAVE THE PRINTER ON! This allows the printer to perform a periodic self maintenance. 09538 Spectrum Z510 Quick Start Guide www.zcorp-users.com...
Page 4
REPARING THE UILD IN RINT OFTWARE 1. Open or import your file(s). 2. Orient and scale the file if needed. 3. Check ‘3D Print Set-up’ in ZPrint Software. 4. Press ‘3D Print’ in ZPrint Software. 09538 Spectrum Z510 Quick Start Guide www.zcorp-users.com...
Page 5
EMOVING THE 1. Wait for part to complete printing. Check software for part orientation. 2. Gross depowder the part and remove from build area. 3. Fine depowder part and post-process as needed. SEFUL ETUP AND ROCESSING 1.1.1 PART SETUP, ORIENTATION, AND PRINT SETTINGS Do not tightly pack parts into the build.
Page 6
To increase the strength of thin parts, you can decrease the layer thickness to 0.0035" (0.089 mm) if you are using one of the zp ® 100 series (plaster-based) powder systems. Then choose to override the saturation values. Input the saturation values used for printing at 0.004"...
Page 7
NFILTRATION WHEN USING Z-BOND TM RESIN 1.1.4 Always infiltrate the most delicate features of the part first. Z-Bond resin gives almost immediate strength to the area of the part that has been infiltrated. As you handle the areas of the part that have been infiltrated it will be less likely to break it. Try to avoid infiltrating the part by applying Z-Bond resin from spot to spot.
Need help?
Do you have a question about the SPECTRUM Z M510 and is the answer not in the manual?
Questions and answers