Layout And Dimensions - Vecow ESI-100 User Manual

1.4 Layout and Dimensions

JM0 : external power 18-36V DC connector
JM1 : Input connector
DISP0 : CardID or module address display
OK : system active LED, flashing per second
RUN : ESC (EtherCAT slave controller) status LED, while
LED off : ESC initialization
LED blinking (slow) : ESC in pre op state
LED single flash : ESC in safe op state
LED on : ESC in op state
LED flickering (fast) : ESC in bootrap state
ERROR : ESC (EtherCAT slave controller) error LED, while
LED off : ESC no error
LED flickering (fast) : ESC error in bootrap state
LED blinking (slow) : ESC error in pre op state
LED single flash : local application error
LED double flash : master is disconnected
LED on : local controller fail
P0 : EtherCAT RJ45 input socket
P1 : EtherCAT RJ45 output socket
Input LED : Input status display
Output LED : Output status display
JM2 : Output connector
©Vecow ESI-100 User Manual GENERAL INTRODUCTION 4