Table of Contents
Advertisement
6
en | Safety
CAUTION!
This product has been tested according to standard CIE/IEC
62471:2006 "Photobiological safety of lamps and lamp
systems" and found to meet Risk Group 2 for exposure limit
4.3.7 "Infrared radiation hazard exposure limits for the eye."
For other hazard exposure limits, the product was found to be
exempt. Risk Group 2 is characterized in the standard as
"products generally do not pose a realistic optical hazard if
aversion responses limit the exposure duration or where
lengthy exposures are unrealistic." Since there is no aversion
response for IR, avoid eye exposure. Risk Group 2 sources do
not pose an infrared radiation hazard for the eye within 10 s
at distances beyond 200 mm or 8 inches.
The Exposure Hazard Value for the product (ratio of the
Exposure level to the Exposure limit) is up to 10 at a test
distance of 200 mm (8 inches). The Hazard Distance
(distance beyond which the product falls into the exempt/
safe group) is at most 640 mm (25 inches). Note that typical
use cases are well beyond the Hazard Distance.
When servicing the unit, physically disconnect the power
supply to avoid possible IR exposure to the eyes. If physical
disconnection is not possible, use appropriate shielding to
block the LED panel or use eye protection with a transmission
of 10% or less at a wavelength of 850 nm.
Coax grounding:
–
–
–
AM18-Q0663 | 1.0 | 2013.09
www.a1securitycameras.com email: sales@a1securitycameras.com
Ground the cable system if connecting an outside cable
system to the unit.
Connect outdoor equipment to the unit's inputs only after
this unit has had its grounding plug connected to a
grounded outlet or its ground terminal is properly
connected to a ground source.
Disconnect the unit's input connectors from outdoor
equipment before disconnecting the grounding plug or
grounding terminal.
Installation manual
Available from A1 Security Cameras
DINION imager 9000 HD
Bosch Security Systems
Advertisement
Table of Contents
