Off Button - Breville VCF126 Manual

TROUBLESHOOTING GUIDE - GRINDER
Problem Possible Cause
Optimum Grind New Burrs are bedding in.
Setting is This is normal for the first
producing an few uses.
under extracted
Beans are losing freshness.
espresso
Not enough coffee grinds
used.
Grinds not tamped
(compacted) enough.
GRINDER The machine is not plugged
LIGHT does not into the power outlet.
illuminate after
The Bean Hopper is not
pressing ON/
seated correctly & not

OFF BUTTON

activating the red Interlock
Pin.
GRINDER Hopper Gates are closed or
LIGHT flashes not fully open.
when trying to
grind beans.
GRINDER Grinder Motor in protection
LIGHT mode to prevent
illuminated red overheating. Grinder has
been used for long periods
in a short space of time.
No coffee grinds No coffee beans in the
coming from the Bean Hopper.
Grinder Outlet
Hopper Gates are closed or
not fully open.
The Grind Chamber or
Outlet is blocked.
Coffee grinds Grind Setting not correct.
are coarse
when on a fine
Grind Setting
Top Burr not seated
correctly. Coffee beans or
grinds are caught around &
under the Top Burr.
Bottom Burrs needs
adjusting.
36
What To Do
Turn the Bean Hopper clockwise
in small increments to a finer Grind
Setting to keep an optimum espresso
extraction. Use the information on
pages 14-15 to help.
Fill with more coffee grinds.
Tamp more firmly. See Espresso
Extraction Guide section, page 15.
Insert in the Power Plug into power
outlet & switch on.
Turn the Bean Hopper in a clockwise
direction to lock into place. See Care
& Cleaning, page 29.
Turn the Bean Hopper in a clockwise
direction to a Grind Setting between
30-0 to fully open the Hopper Gates.
See Removable Bean Hopper
section, page 8.
Leave the Grinder for 5 minutes.
The GRINDER LIGHT will illuminate
white to indicate normal use can be
resumed.
Fill the Bean Hopper with freshly
roasted coffee beans.
Turn the Bean Hopper in a clockwise
direction. At Grind Setting 30, Hopper
Gates are fully open. See Removable
Bean Hopper section, page 8.
Grinder needs cleaning. See Care &
Cleaning, pages 28-29.
Adjust the Grind Settings by turning
the Bean Hopper. See Tips for
Grinding, & Extraction, pages 14-15.
Top Burr needs cleaning.
See Care & Cleaning, pages 28-29.
See Adjusting the Bottom Burr section
on, page 29.