Breville VCF126 Manual page 31

DESCALING CYCLE - ESPRESSO MACHINE
Note: The LIGHT will continue to flash
until completion of the Descaling Cycle.
Important: If Descaling Step 1 is not
started within 1 minute of entering the
Descaling Cycle, the machine will exit
the Descaling Cycle and go back to the
READY state.
Important: The Descaling Cycle can
be exited at any point by pressing the
BUTTON.
Step 1. Start Descaling Cycle
- Turn the DIAL to the STEAM position.
- The STEAM LIGHT will now be fully
illuminated.
- The Pump will start and hot water will
run from the Group Head & Steam
Wand. Over a 2 minute period the
Pump will make different noises.
- When hot water has stopped being
released from the Group Head &
Steam Wand, this step is fi nished.
- To indicate the machine has fi nished
this step the machine will beep,
the STEAM LIGHT will stop being
illuminated and the DIAL LIGHT will
now start to fl ash.
- Turn the DIAL to the vertical position.
- The DIAL LIGHT will now be fully
illuminated.
- Move to Step 2.
Step 2. Preparing for Purge
Important: There is a maximum of 5
minutes allowed to complete this step
before the Descaling Cycle will exit.
- The Steam Wand & Group Head now
need to be purged clean with fresh
water to remove descaling solution.
• Rinse Water Reservoir
- Remove the Water Reservoir and
rinse thoroughly under running
water, ensuring that all traces of
the descaling solution have been
removed.
• Fill Water Reservoir
- Fill the Water Reservoir to the '1 Litre'
line with cold water from the tap and
insert into position.
• Empty Containers
- Empty water from the containers and
replace.
- Move to Step 3.
Step 3. Start Purge
- Turn the DIAL to the STEAM position.
- The STEAM LIGHT will now be fully
illuminated.
- The Pump will start and hot water will
run from the Group Head & Steam
Wand. Over a 2 minute period the
Pump will make different noises.
- When hot water has stopped being
released from the Group Head &
Steam Wand, the Descaling Cycle is
complete.
Descaling Cycle Complete
- To indicate the completion of the
Descaling Cycle the machine will beep
and the LIGHT will stop fl ashing.
- The STEAM LIGHT will stop being
illuminated and the DIAL LIGHT will
now start to fl ash to prompt the return
of the DIAL to the vertical position.
- Turn the DIAL to the vertical position.
- The machine will return to the READY
state.
Descaling Cycle Clean Up
- Empty water from the containers and
clean, ensuring that all traces of the
descaling solution have been removed.
31