Steam Button/Hot Water Button; Auto Purge Function - Breville 800ESXL Manual

STEAM BUTTON/HOT WATER BUTTON

• The Steam button surround will automatically
illuminate when the machine is switched 'On'
with the Power On/Off button.
• The machine will always automatically default
to the Steam button when the appliance is
first switched on.
• Both buttons cannot be operated at the same
time.
• To select steam: when the Steam button
surround is illuminated, just set the Selector
Control to 'Steam'
• To select hot water: press the Hot Water
button and the surround will illuminate, then
just set the Selector Control to 'Steam'.
• If the machine remains switched 'On', the last
button function used (Steam or Hot Water)
will stay illuminated.
CAUTION: DO NOT ALLOW MILK TO RUN OVER THE TOP OF THE FROTHING ATTACHMENT, OTHERWISE IT WILL NOT
FUNCTION PROPERLY.
TO AVOID SPLATTERING OF HOT MILK, DO NOT LIFT THE END OF THE FROTHING ATTACHMENT ABOVE THE
SURFACE OF THE MILK WHILE FROTHING.
ENSURE THE SELECTOR CONTROL IS IN THE 'STANDBY' POSITION BEFORE REMOVING THE FROTHING JUG.
NOTE: Always ensure that the
Frothing Attachment has been
firmly pushed onto the Steam
Wand and connects with the
rubber surround.
For best results use cold fresh
milk (low fat milk will froth easier).
Always clean the Steam Wand
and Frothing Attachment after
every use. Refer to Care and
Cleaning on Page 20.

AUTO PURGE FUNCTION

For brewing more coffee immediately after using
the steam function, the 800ESXL features an
auto-purge function. This ensures that ground
coffee will not be burnt by the initial water flow
from the thermoblock that could be too hot.
Instead this water is automatically released
internally into the Drip Tray ensuring that the
internal thermostat is at optimal temperature for
extracting coffee. Your coffee will always be
extracted at this optimal temperature ensuring
only the best flavored coffee is achieved.
HOW TO FROTH MILK FOR A CAPPUCCINO OR LATTÉ
19