Replace The 12 V Circuit Breaker On The Front Panel - Hypertherm Freedom 38 PPA Service Manual

Replace the 12 V circuit breaker on the front panel

Kit number
428743
Remove the 12 V circuit breaker
1. Turn OFF the system. Make sure the power switch on the front panel is in the OFF (O) position.
2. Wait for 30 seconds, then disconnect the battery's negative (-) ground cable.
3. Remove the top cover from the system. See Remove the cover on page 86.
4. From behind the front panel, disconnect the red wire
12 V circuit breaker
5. Gently pull on the circuit breaker from outside the front panel. At the same time, slowly push the back of the circuit
breaker through the lock washer
Freedom 38 PPA Service Manual 809010
Description
Kit: 12 V circuit breaker 10 A
.
3
3
.
4
and the red and red/black wire pair
1
Figure 28
4
3
2
4
3 – System-Level Components
from the back of the
2
1
95