Tesla Air 6 User Manual page 5

CONTROL PANEL
On / Off switch - On / Off
To turn the purifier on / off, press the On / Off button. The device
turns on in "Auto" mode and analyzes the air quality for one
minute. After this time, it adjusts itself to the selected speed,
informing at the same time what the current air quality is. To turn
it off, press the On / Off button.
Air supply operation selection - Air volume
• Sleep: Fan silent at low speed, "SLEEP" sign on.
• Mid: fan runs at medium speed, "MID" sign is on.
• High: the fan runs at high speed, "HIGH" indication is on.
• Max: the fan runs at maximum speed, "MAX" marking is on
AUTO function
In "AUTO" mode, the sensor detects the room air quality and
automatically adjusts the fan speed to the air quality in real
time.
• Press the "AUTO" button, the "AUTO" mark is on.
• In "AUTO" mode, the dust sensor checks the air quality in the
room and automatically adjusts the fan speed. At the same
time, the digital display shows both PM2.5 data and humidity
up to 10 seconds apart.
• In the "AUTO" mode, both the ionizer and humidification are
turned on, and the device analyzes whether to activate the
humidification function according to the current degree of
humidity in the room. If there is not enough water in the water
tank, the "Water Shortage" indicator light will come on.
• In "AUTO" mode, you can press "Air volume" button to exit
"AUTO" mode, and the unit will switch to manual mode.
Each time you press "Air volume", the fan mode changes to
"SLEEP" --- "MID" --- "HIGH" --- "MAX", which is indicated by the
corresponding LED lighting up.
• After connecting the socket (in operating or standby mode),
hold the "AUTO" button for 3 seconds to activate the WiFi
network search mode for remote operation - when the purifier
can be paired with a mobile device, the diode will start flashing
quickly. When connecting to the Internet, the WIFI LED blinks
slowly and when pairing, the LED lights continuously.
Humidifying function – Humidifying
• While the device is operating, press the "Humidifying" button
to turn on or off the humidifying function.
• In "AUTO" mode, the humidity sensor will test the humidity and
automatically adjust this function to the appropriate humidifier
operating mode.
a) When the "Humidifying" function is turned on and there is
enough water in the tank, the sensor will automatically adjust
the function:
b) When the room humidity is less than 45%, the device will
activate this function.
c) When the room humidity exceeds 60%, the device will
disable this function.
d) Turning on the "Water Shortage" diode means that there is
insufficient water in the tank and the "Humidifying" function will
automatically turn off. To resume its functioning, water must be
refilled.
The need to replace the filter – the diode is
signaled in red
e) When the maximum filter life is reached, the red filter change
indicator will come on to remind the user to change filters with
new ones.
f) After replacing the filters, reset the device by holding down the
"AUTO" button and the "Humidifying" button simultaneously for
3 seconds, until the red indicator light turns off and you will hear
two "Bee" sounds. From that moment on, the filters' working time
is counted down again.
Attention: Please do not perform a reset if the filter replacement
LED is not lit to avoid miscalculation of the filter operating time.
5
ENG