Tesla Air 6 User Manual page 3

DEVICE DESCRIPTION
A back housing acts as a pre-filter (air intake)
B. High-performance HEPA filter combined with an activated
carbon filter
C. Water container
D. Water filter
E. Control panel
F. Air outlet
G. Left and right handle
H. Dust sensor
I. Humidification sensor
USING AN AIR PURIFIER
Turning on and off
To start the device, connect it to the power supply and press the
ON / OFF button
Attention!!!
• The air purifier should be place on a flat, stable and even
surface, in such way that the front of the appliance does not
face walls or furniture.
• For optimal cleaning, close the doors and windows.
• Be careful not to let the curtains fall over the air inlet or outlet.
Multiple filtration and humidification process
Pre-filter: Captures hair, fur and other large-particle debris; it also
has the function of extending the life of the HEPA filter.
HEPA Filter: HEPA filter effectively removes dust particles larger
than 0.3 microns, including parts of PM2.5 and PM5-10 particles.
Installation, replacement of filters
To replace the filters, follow the instructions below.
Attention ! Before disassembly and assembly, make sure that the device is disconnected from the electrical socket
Attention ! all new filters are placed in plastic bags - they must be removed before placing them in the device.
Fig. 1
Remove the
back cover by
holding your
hands on the
top two latches,
and remove it.
(Fig. 1)
Carbon filter: effectively removes various harmful gases, e.g.
formaldehyde.
Water filter: its purpose is to clean the water, add it to the
humidifier's water tank.
Ions - The release of ions helps to further purify the air.
Fig. 2
Remove the
filter by gently
pulling the tape
on top of the
filter. (Fig. 2)
3
ENG
Fig. 3
Take the filter out
of the plastic bag.
(Fig. 3)