Menu Parameter; Register Address - Biddle Modbus Manual

en
F
REQUENTLY USED REGISTER ADDRESSES
421 Turning the heating on and off
422 Manual setting of the strength

MENU PARAMETER

1
0.6
423 Adjusting the automatic strength con-
trol
en-16
The unit's heating can be switched on and off manually.
Switching the heating off disables the room temperature con-
trol .
If the heating has been switched on via this function, it may
occur that the automatic control switches the heating off
again. This may be due to an external signal, for example, or
because the desired temperature has been reached.
The heating can also be switched off by the control itself.
With the manual setting, you can select the strength. To
achieve maximum comfort with minimum energy consump-
tion, Biddle recommends selecting the lowest strength at
which the airflow touches the ground. This setting may possi-
bly need to be changed during the course of the day.
The unit can only be controlled manually if the functions
below have been set as follows:

REGISTER ADDRESS

-
405
In automatic mode, the strength and temperature of the air-
flow are regulated automatically. Due to weather conditions,In
certain circumstances, you might want to adjust the automatic
setting. If you feel a cold draught along the floor, you can
increase the automatic strength.
The unit can only be controlled automatically if the functions
below have been set as follows:
DESCRIPTION
Select modes
(Options for modes)
Automatic or manual control
Current status
Caution: Use this address only for
reading out. Use 425 for writing.
M / BAC
ODBUS NET
VALUE
1 = allowed: manual
3 = allowed: manual,
automatic
0 = manual