Transmission - Ducati MULTISTRADA V45 Owner's Manual

Lever with knob to adjust the distance to handgrip
on handlebars.
Brake lever master cylinder diameter: 16 mm (0.63 in)
Brake lever master cylinder PR 18/19.
Front brake calliper
Make: Brembo, Monobloc Evo M50 Stylema with
radial mount, 4 pistons and two pads, Radial master
cylinder (ABS Evo Cornering)
Front brake type: No. 4 pistons Ø30 mm (1.18 in).
Friction material: BRM10A HH.
Front brake master cylinder
Brake master cylinder type: PR18/19.
REAR
Rear brake disc
With fixed drilled steel disc.
Disc diameter: 265 mm (10.43 in).
Disc braking surface: 210 sq. cm (32.55 in
Front brake disc thickness: 6 mm (0.24 in).
Maximum wear on disc thickness: 5.4 mm (0.21 in).
Rear brake control
Hydraulically operated by a pedal on RH side.
Rear brake calliper
Brake calliper make: BREMBO, PF 2x28 D with
cornering ABS as standard.
Rear brake type: PF 2x28 D.
Number of pistons: 2.
Piston diameter: 28 mm (1.1 in).
Friction material: TOSHIBA TT 2182 FF.
Rear brake master cylinder
Brake master cylinder type: PS 13.
Master cylinder diameter: 13 mm (0.51 in).
Fixed, 28 mm (1.10 in) diameter 2-piston calliper.
Attention
The brake fluid used in the brake system is
corrosive.
In the event of accidental contact with eyes or skin,
wash the affected area with abundant running water.

Transmission

Hydraulically-controlled slipper wet multiplate
clutch
Drive is transmitted from engine to gearbox primary
2
).
shaft via spur gears, 1.80:1 ratio.
Front chain sprocket/clutch gearwheel ratio: 30/54.
6-speed gearbox with constant mesh gears, gear
change pedal on left side of motorcycle equipped
with Ducati Quick Shift /DQS) up/down EVO.
Gearbox output sprocket/rear chain sprocket ratio:
16/42.
Total gear ratios:
321