Switch Settings On Boards - Sony NSP-1 Service Manual

1-5. Switch Settings on Boards

DEC-158 Board
A B
1
2
3
4
DEC-158 board (A side)
Ref. No. Bit Name
S801 — Reset button
S802 1 IP address
display switch
2 —
3 IP address
initialize switch
4 Service mode
selection switch
1-6 (E)
D
C
S801
S802
Description
Restarts the unit.
When the power of the unit is turned on while this switch
is on, IP address of the unit is displayed on devices
(color monitor, etc.) connected to the unit.
n
The operation process is temporarily suspended while the
IP address is displayed, but when this switch is turned off,
the unit will start operating normally.
Not used
When the power of the unit is turned on while this switch
is on, the IP address of the unit is initialized to the factory
setting.
m
. Factory setting
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.254
. The operation process is temporarily suspended after
the initialization of the IP address is completed, but
when this switch is turned off, the unit will start operating
normally.
. If the wireless LAN has been activated, it will be
deactivated and Ethernet will be activated.
When the power of the unit is turned on while this switch
is on, the service mode setting window is displayed on
devices (color monitor, etc.) connected to the unit.
n
Contact your local Sony Sales Office/Service Center for
the log in ID and password.
Factory setting
—
OFF
OFF
OFF
OFF
NSP-1