Ramp Cover Removal - BraunAbility Simple Stow Infloor Service Manual

Simple Stow Infloor Ramp Cover Removal
The infloor ramp assembly is accessible by remov-
ing the top cover.
Note: If equipped with optional mid-point seat,
remove the seat and associated hardware.
1. Remove ramp pole. Unscrew pole assembly
from the ramp platform.
2. Remove driver side slide door threshold plate.
The threshold is secured with (4) screws on
the top of the plate.
Driver Side
Slide Door
Threshold Plate
Rear Trim
Plate
Securement
Track
*
Note: To access front threshold securement
screw, B-Pillar interior panel must be removed.
3. Remove the rear trim plate. The trim plate is
secured with (6) screws.
4. Remove the ramp top cover. The cover is
secured with (6) screws on the top of the cover
and (2) screw on the outboard face of the pas-
senger slide door threshold plate.
5. The cover assembly consists of the cover /
ramp transition plate / passenger slide door
*
threshold and the (2) 5" sections of secure-
ment track. Tilt the cover assembly rear edge
upward and back pulling the cover from under
the securement track that is behind the front
seats. Carefully remove cover.
6. To install the ramp cover, reverse the removal
procedure.

Ramp Cover Removal

Ramp
Pole
Page 17