To Select The Programming Mode; Programming Logic; To Enter The Programme Parameters - emmeti Zona Operating Instructions Manual

To Select the Programming Mode

Hold & together for 3 seconds to enter the programming function.
Using the & , select the required Programming Mode.
Use to confirm your selection.

Programming Logic

When programming this thermostat you will be asked to enter a time and then the temperature you require at that time. You can set 4 time/
temperature switches through a single day.
E.g. 07:00 & 22°C > 10:00 & 18°C > 15:00 & 22°C > 22:00 & 18°C
With these temperature settings, the heating will be increased to 22°C by 07:00 and maintain that temperature until 10:00 when the
temperature requirement will switch to 18°C. This new temperature will be maintained until 22°C is required at 15:00, 22°C will be maintained
until 22:00 when only 18°C is required. This last time setting will maintain the specified temperature until 07:00 the next morning*.
*Description simplified for clarity. Building, heat up & cool down rates are not explained here, and will vary according to various external parameters.
Programming Logic
22°C
TEMP 20°C
18°C
00.00

To Enter the Programme Parameters

Hold & together for 3 seconds to enter the programming function.
Use to confirm your selection.
The time display will be flashing – use
The temperature display will now be flashing – use
Repeat these steps for the remainder of that day, then as necessary depending on your programming mode after that.
4
02.00 04.00 06.00 08.00
& to change the hours and press
&
10.00 12.00 14.00 16.00
TIME
to confirm. Repeat for the minutes.
to select the desired temperature and press
Maintained Temperature
Heat up/cool down varies dependent
on building fabric and response times
18.00 20.00 22.00 24.00
to confirm.
ZONA Operating Instructions