Table of Contents
Advertisement
PCI IDE BusMaster [Enabled]
PCI IDE BusMaster [Enabled]
PCI IDE BusMaster [Enabled]
PCI IDE BusMaster [Enabled]
PCI IDE BusMaster [Enabled]
Allows BIOS to use PCI bus mastering when reading/writing to IDE devices.
Configuration options: [Disabled] [Enabled]
IRQ xx assigned to [Available]
IRQ xx assigned to [Available]
IRQ xx assigned to [Available]
IRQ xx assigned to [Available]
IRQ xx assigned to [Available]
When set to [Available], the specific IRQ is free for use of PCI/PnP devices.
When set to [Reserved], the IRQ is reserved for legacy ISA devices.
Configuration options: [Available] [Reserved]
5.4.6
5.4.6
USB Configuration
USB Configuration
5.4.6
5.4.6
5.4.6
USB Configuration
USB Configuration
USB Configuration
The items in this menu allows you to change the USB-related features.
Select an item then press Enter to display the configuration options.
Onboard SiS USB1.1 DEVICE
Onboard SiS USB2.0 DEVICE
USB Configuration
Module
Version - 2.23.2-9.4
USB Devices Enabled: None
Legacy USB Support
USB 2.0 Controller Mode
Stop EHCI HC in OHCI handover
OnBoard SiS USB 1.1 Device [Enabled]
OnBoard SiS USB 1.1 Device [Enabled]
OnBoard SiS USB 1.1 Device [Enabled]
OnBoard SiS USB 1.1 Device [Enabled]
OnBoard SiS USB 1.1 Device [Enabled]
Allows you to enable or disable the onboard SiS USB 1.1 device.
Configuration options: [Disabled] [Enabled]
OnBoard SiS USB 2.0 Device [Enabled]
OnBoard SiS USB 2.0 Device [Enabled]
OnBoard SiS USB 2.0 Device [Enabled]
OnBoard SiS USB 2.0 Device [Enabled]
OnBoard SiS USB 2.0 Device [Enabled]
Allows you to enable or disable the onboard SiS USB 2.0 device.
Configuration options: [Disabled] [Enabled]
•
The Module Version and USB Devices Enabled items show the
auto-detected values. If no USB device is detected, the item shows
None.
•
Set to [Disabled] if you are using a Windows
OS.
Legacy USB Support [Auto]
Legacy USB Support [Auto]
Legacy USB Support [Auto]
Legacy USB Support [Auto]
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB devices. Setting to
Auto allows the system to detect the presence of USB devices at startup.
If detected, the USB controller legacy mode is enabled. If no USB device is
detected, the legacy USB support is disabled.
Configuration options: [Disabled] [Enabled] [Auto]
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
[Enabled]
[Enabled]
[Auto]
[HiSpeed]
[Enabled]
®
98SE or Windows
®
ME
5 - 2 5
5 - 2 5
5 - 2 5
5 - 2 5
5 - 2 5
Advertisement
Table of Contents
