Table of Contents
Advertisement
Bootup Num-Lock [On]
Bootup Num-Lock [On]
Bootup Num-Lock [On]
Bootup Num-Lock [On]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
PS/2 Mouse Support [Auto]
PS/2 Mouse Support [Auto]
PS/2 Mouse Support [Auto]
PS/2 Mouse Support [Auto]
PS/2 Mouse Support [Auto]
Allows you to enable or disable support for PS/2 mouse.
Configuration options: [Disabled] [Enabled] [Auto]
Wait for 'F1' If Error [Enabled]
Wait for 'F1' If Error [Enabled]
Wait for 'F1' If Error [Enabled]
Wait for 'F1' If Error [Enabled]
Wait for 'F1' If Error [Enabled]
When set to Enabled, the system waits for the F1 key to be pressed when
error occurs. Configuration options: [Disabled] [Enabled]
Hit 'DEL' Message Display [Enabled]
Hit 'DEL' Message Display [Enabled]
Hit 'DEL' Message Display [Enabled]
Hit 'DEL' Message Display [Enabled]
Hit 'DEL' Message Display [Enabled]
When set to Enabled, the system displays the message "Press DEL to run
Setup" during POST. Configuration options: [Disabled] [Enabled]
Interrupt 19 Capture [Disabled]
Interrupt 19 Capture [Disabled]
Interrupt 19 Capture [Disabled]
Interrupt 19 Capture [Disabled]
Interrupt 19 Capture [Disabled]
When set to [Enabled], this function allows the option ROMs to trap
Interrupt 19. Configuration options: [Disabled] [Enabled]
5.6.5
5.6.5
Security
Security
5.6.5
5.6.5
5.6.5
Security
Security
Security
The Security menu items allow you to change the system security settings.
Select an item then press <Enter> to display the configuration options.
Security Settings
Supervisor Password
User Password
Change Supervisor Password
Change User Password
Clear User Password
Change Supervisor Password
Change Supervisor Password
Change Supervisor Password
Change Supervisor Password
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on top of the screen shows the default N o t I n s t a l l e d
After you set a password, this item shows I n s t a l l e d
To set a Supervisor Password:
1.
Select the Change Supervisor Password item and press <Enter>.
2.
From the password box, type a password composed of at least six
letters and/or numbers, then press <Enter>.
3.
Confirm the password when prompted.
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
A S U S V i n t a g e - P E 1
: Not Installed
: Not Installed
<Enter> to change
password.
<Enter> again to
disabled password.
N o t I n s t a l l e d.
N o t I n s t a l l e d
N o t I n s t a l l e d
N o t I n s t a l l e d
I n s t a l l e d.
I n s t a l l e d
I n s t a l l e d
I n s t a l l e d
5 - 3 1
5 - 3 1
5 - 3 1
5 - 3 1
5 - 3 1
Advertisement
Table of Contents
