Haltech iC-7 Quick Start Manual page 7

iC-7 TO OBD-II INSTALLATION
The iC-7 to OBD-II CAN Cable allows the
Haltech iC-7 Dash to display the data obtained
from the vehicle's OBD-II system in real-time.
This cable also provides a power source to the
dash.
The +12V Supply from the vehicle's OBD II
connector is constant and would cause the dash
to be powered even when the vehicle is off.
For this reason, the RED power wire must be
connected to a switched +12V "Key On" power
source in the vehicle as per the diagram (ie.
connection to switched +12V supply)
Please refer to your specific ECU wiring
diagram for more information.
Haltech iC-7 OBD-II Dash (HT-067012)
comes supplied with a 1400mm (55")
OBD-II CAN Cable (HT-135003).
This cable is used to connect the
Haltech iC-7 to your car's OBD-II port.
Connect to
the OBD-II port
on your vehicle
FUSE
IGNITION
SWITCH
3A
12
ECU configuration for Elite Series ECUs
1. Connect to the ECU with the ESP software
(Elite Software Programmer)
2. Go into "Main Setup" (press F4)
3. Click "Devices" on the left tab
4. Under Haltech CAN System, enable the
Haltech CAN Supported Dash (see below)
5. For extended functionality of the iC-7 Display
Dash, Elite firmware 2.35 or later is required.
Earlier firmware versions are supported, but
some channels may not display.
GROUND
CAN Connection: DTM-4 receptacle
Pin Number Connection
1 +12V Supply
2 Battery Ground
3 CAN High
4 CAN Low
CAN Connection: 34 pin Superseal Connector
Pin Number Connection
1 CAN High
2 CAN Low
3 +12V Supply
4 Battery Ground
Connecting iC-7 Display Dash to a Haltech Platinum Series ECU:
You will need to use an 8-pin Tyco to DTM-4 cable to connect all Platinum Series ECUs to
this device. This cable is supplied with the ECU.
If you already have a Platinum Series ECU and are adding the iC-7 display dash to your
system this cable can be purchased separately (HT-130040).
13
Rear View, Wire Side
Rear View, Wire Side