Emerson 1410S Reference Manual page 8

Configuration
September 2020
Gateway are operationally equivalent and the following instructions are applicable to
both.
Powering the Gateway
For the Emerson 1410S, bench top power will be needed to power the Gateway by wiring a
10.5–30 VDC (24 VDC if configured with I.S. barriers) power source. See
specifications
Figure 2-1: Emerson 1410S Gateway Wiring
A. Mounting plate
B. Emerson Wireless 781S Smart Antenna terminal 1 power and data connections
C. Emerson Wireless 781S Smart Antenna terminal 2 power and data connections
D. Ethernet port 1. When this port is activated, the factory IP address is 192.168.1.10.
E. Ethernet port 2. When this port is activated, the factory IP address is 192.168.2.10.
F. Emerson 1410S power and serial connections
CAUTION
Equipment damage
Connecting through the open terminal block cover may stress the connections and
damage the Gateway.
When making physical connections to the Gateway, the installer should route wire for the
Emerson 781S units through the left side entries using a separate entry for each. Power,
Ethernet, and serial Modbus
entries.
2.3.1 Establishing a connection
Connect the PC/laptop to the Ethernet 1 (Primary) receptacle on the Gateway using an
Ethernet cable. This process will only need to be done once for the two networks. The
networks have the same IP address even if you are running two separate networks.
8
for power requirements or
®
wiring should be routed through the right side wiring
Reference data for specifications.
Reference Manual
00809-0600-4410
Power
Emerson.com