Emerson 1410S Reference Manual page 39

Reference Manual
00809-0600-4410
Figure 5-3: Modbus Communications Page
Single Modbus
Address
Multiple Modbus
Addresses
Modbus TCP Port
Baud Rate
Parity
Stop Bits
Emerson 1410S/781S
When selected, this address is used by the Gateway for Modbus
RTU communications.
When selected, a new address column will appear on the
Modbus mapping page.
This is the TCP/IP port the Gateway uses for Modbus TCP
(Ethernet). To change TCP/IP port settings, see the Internal
Firewall section for more details.
The data rate or speed of serial communications. This setting is
only required for Modbus RTU.
This setting determines parity (none, even, or odd) used for error
checking purposes. This setting is only required for Modbus RTU.
This setting determines the number (1 or 2) of stop bits used
when ending a message. This setting is only required for Modbus
RTU.
Operation and maintenance
September 2020
39