Electrical Installation - Asko T712C Operating Instructions Manual

Installation

Electrical installation

The machine must only be connected to an
earthed wall socket.
If this appliance is supplied from a cord exten-
sions set or electrical portable outlet device,
the cord extension ser or electrical portable
outlet device must be positioned so that it is
not subject to splashing or ingress of mois-
ture.
Connection on delivery
The machine is supplied as 1-fas, 230V, with
a heat output of1950W and a 10A fuse. Any
earth fault fuses must be type A.
Switch-over
It is possible to switch over from 10A (heat
output 1950W) to 16A (heat output 2500W).
1. Shut off the power.
2. Press and hold the Start/Stop button, and
switch on the power
3. Release the Start/Stop button once the
program indicator lights up.
4. Press the Start/Stop 5 times (within 10
seconds).
5. Adjust the program selector so that the
Extra dry light comes on (10 o'clock).
6. Press the Start/Stop button to store the
setting:
If you want to reset the machine to a 10A
connection:
1. Repeat steps 1-4.
2. In step 5, turn the program selector until
the Extra dry light goes out.
3. Press the Start/Stop button to store the
setting.
The machine now has 10A connection.
21