Installation; Positioning The Tumble Dryer - Asko T712C Operating Instructions Manual

Installation

Positioning the tumble dryer

The tumble dryer can be free-standing or in
a stack. Remember that the tumble dryer
produces heat and should therefore not be
located in a room that is too small. If the room
is very small, drying will take longer due to
the limited quantity of air.
Caution!
The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
Caution!
The ventilation in the tumble dryer's plinth
must not be blocked by a carpet or rug.
Tip!
To improve ventilation, leave the door to the
room where the tumble dryer is located open.
Caution!
Any electrical installation must be carried out
by qualified professionals.
A. Free-standing
The tumble dryer can be positioned beside
the washing machine.
B. Stack
The tumble dryer can be placed on top of a
Asko washing machine. In this case you use
the stacking attachments (foot cups and anti-
tilt devices) that come with the machine: You
will find 2 foot cups in a bag in the drum and
2 anti-tilt devices are attached to the bottom
left corner at the back of the machine. Extend-
ing plates can be ordered from your local re-
tailer.
How to assemble the stack:
1. Undo the anti-tilt device.
2. Undo the two screws indicated on the back
of the washing machine.
3. Secure the anti-tilt device using the screws
as shown in the picture.
4. Attach the plastic cups for fixing the tumble
dryer's front feet to the washing machine's
top cover. This is essential, as only when
the tumble dryer's feet are resting in the
plastic cups can you be sure that the dryer
is correctly positioned on the washing ma-
chine.
Break off tag A on the cup fitted on the
right-hand side and tag B on the cup fitted
on the left-hand side. Then remove the
paper from the self-adhesive surface under
the plastic cups.
19