Adjusting The Feet; Condensed Water - Asko T712C Operating Instructions Manual

Installation
A
B
5. Fit the plastic cups so that the "tags"
marked with arrows are against the front
edge or side edge of the cover and press
them firmly onto the cover. Then break off
the remaining tags.
6. Push out the knock-out hole on the back
of the dryer (you must not remove it, just
open it) using a hammer and screwdriver.
7. Push the tumble dryer in under the metal
brackets. At the same time keep the front
edge raised by 10 mm to 20 mm.
8. Lower the tumble dryer's front feet into the
plastic cups and adjust the dryer to ensure
that it is balanced.
20

Adjusting the feet

Screw the feet in or out so that the tumble
dryer is steady and balanced on the floor or
on the washing machine. Then tighten the
lock nuts.

Condensed water

The machine is supplied as shown in Option
1 (inset). This means that the condensed
water is pumped into the condensed water
container. This must then be removed and
emptied by hand.
Option 2 allows you to remove the small short
hose from the nipple. Attach the rubber hose
supplied to the same nipple. The water can
then be pumped out into a sink or a floor drain
(2a).
2
1
2a
Locking nut
Max 1000 mm