Troubleshooting - Jacuzzi hydromassage Use & Maintenance

Troubleshooting

The hydromassage does not start
The hydromassage stops by itself
Few air bubbles come
from the largest nozzles
The pressure from the
hand shower is too low
W
e always recommend carefully reading the manual; in the instance that there is an issue,
refer to the following guide.
Tub area
- check that the master switch on the power line is on.
- if, when you try to start the hydromassage, you hear a beep (in some models the light also
flashes), this means that the water level in the tub is too low: see the relevant section.
- check that there is no blackout.
- the hydromassage time is preset by default for approximately 20 minutes and therefore
stops automatically after this time. Simple press the start button again.
- if, when you try to start the hydromassage, you hear a beep (in some models the light also
flashes), this means that the water level in the tub is too low: see the relevant section.
- check that the nozzles are open.
- set the air adjustment knobs.
- clean the suction nozzle(s) as shown in the "Maintenance" chapter.
Clean the hydromassage nozzles as shown in the "Maintenance" chapter.
- unscrew the hand shower from the flexible hose and check that filter is clean and free
from lime scale.
44