Sanitising The Water Circuit; Models Without Sanitisation System - Jacuzzi hydromassage Use & Maintenance

Sanitising the
If you wish to sanitise the water circuit of the tub (recommended frequency: approximately
once a month), we recommend to use J-MX 07 disinfectant, purchasable from Jacuzzi® Servi-
water circuit
ce Centres and Authorised Retailers.
For sanitization, you can use the same water used for hydromassage so long as no soaps,
oils, or cosmetic products have been used. Otherwise, you can use "fresh" water (that is, by
emptying the tub and filling it again). In both cases, the water level, without anybody in the
water, must completely cover the highest hydromassage nozzles.
A
Models without
sanitisation system
B
JACUZZI
by ®
■ Operate the adjustment knobs on the face plate (A) to shut off the air: this will prevent
forming foam while the pump is running.
Also check that all the hydromassage nozzles are open.
■ To run a sanitisation cycle, pour 50-150 ml of J-MX 07 liquid into the water (according
to the water content in the tub) and run the hydromassage for approximately 1 minute
(button B).
■ Turn the pump off and wait for the liquid to take effect for a further 10 minutes.
■ Activate the hydromassage again for just over 1 minute and then turn the pump off.

Open the drain and empty the tub.
39