Troubleshooting; Hydromassage Does Not Start; The Hydromassage Stops Of Its Own Accord; The "Strength" Of The Hydromassage Has Got Weaker - Jacuzzi J.Touch Use & Maintenance

Troubleshooting...

Hydromassage
does not start
1
The hydromassage stops
of its own accord
1
The "strength" of the hydromas-
sage has got weaker;
not many air bubbles come out of
the larger hydromassage outlets
W
e always recommend carefully reading the manual before using your tub; in the instance
that there is an issue, refer to the following guide (some operation faults are presented
on the J.touch remote control display by the switching on and/or flashing of remote control
keys).
lack of electric energy
command not accepted
insufficient water level
lack of electric energy
the selected hydromassage pro-
gramme is finished (each programme
has its own duration, after which time,
the hydromassage stops on its own)
insufficient water level
the outlet nozzles are closed
poor hydromassage intensity
obstructed air outlets and/or hydro-
massage
41
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician)
- try to keep the key on the remote control held
down again (also follow the instructions in the
relative chapters)
- add water until it covers the highest nozzles
on the backrest, so they are immersed and
keep the key held down once again
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician)
- where desired, re-start the hydromassage (re-
fer to the relative chapter)
- add water and restore to the level; if the func-
tion does not automatically re-start, re-start it
by holding the relative key down once again.
- open the nozzles (refer to Chapter "prelimi-
nary operations - some recommendations")
- use "+" on the remote control, as indicated in
the relative chapters.
- clean the outlets as described in the Chap-
ter "Maintenance"; where this is not sufficient,
contact a Jacuzzi® Support Centre.