Toshiba E-STUDIO2323AM Topaccess Manual page 50

5.[Administration] Tab Page
Item name
1 Protocol
 The protocol selecting list of the Wake Up setting is made to select the desired protocols regardless of whether the
selected protocol is enabled or disabled on each protocol setting. If the selected protocol is disabled in its protocol
setting, however, the Wake Up setting is disabled too and therefore this equipment will not be recovered from the
Sleep mode.
 When no response is returned from this equipment after you access the network even if a protocol selected on this
setting is used, retry the access.
For communications using the following protocols, or for "unicast" communications that specify addresses, even if
wake up settings are not applied, the device can return from the Sleep mode.
 IPP
 FTP
 HTTP
 SMTP
 SNMP
 RAW9100
 LPD
 WebService
50 [Setup] Item List
Select the protocols to be used for recovering this equipment from the Sleep
mode. The selectable number of protocols differs depending on the models.
 ARP
Select this to enable address resolution when this equipment is used under
IPv4 environment.
 SNMP for IPv4
Select this to search this equipment over the network with SNMP protocol
when Client Utilities is used under IPv4 environment.
 SNMP for IPv6
Select this to search this equipment over the network with SNMP protocol
when Client Utilities is used under IPv6 environment.
 Neighbor Discovery(Link Local Address)
Select this to enable address resolution when this equipment is used under
IPv6 environment.
 LLTD
Select this to search this equipment over the network with Nmap display
when Network Mapper is used.
 Web Services for IPv4
Select this to search this equipment over the network with WS-Discovery
under IPv4 environment.
 Web Services for IPv6
Select this to search this equipment over the network with WS-Discovery
under IPv6 environment.
Description