Toshiba E-STUDIO2323AM Topaccess Manual page 48

5.[Administration] Tab Page
Item name
Enable Authentication Trap
5
6 Enable Alerts Trap
7 IP Trap Address 1 to 10
8 IPv6 Trap Address 1 to 10
9 IP Trap Community
 Setting up LLTD Session
Enable this setting for confirming the device connection status or accessing the TopAccess. This setting also allows
you to discover the desired device over the local network and view device information such as location, IP address,
MAC address or profile on the Network Map under the Windows 7/Windows 8/Windows Server 2008/Windows Server
2012 environment.
1
2
Item name
1 Enable LLTD
2 Device Name
48 [Setup] Item List
Select whether to send SNMP Traps when this equipment is accessed using
SNMP from a different read community. [Enable] is set as the default.
Select whether to send SNMP Traps when an alert condition occurs. [Enable]
is set as the default.
Enter the IP address where the SNMP Traps will be sent. You can specify up to
10 addresses. Specify within the range from 0 0 0 0 to 255 255 255 255.
Enter the IPv6 address where the SNMP Traps will be sent. You can specify up
to 10 addresses. Specify within the range from 0:0:0:0:0:0:0:0 to
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.
Enter the trap community name for the IP Traps. You can enter up to 31
alphanumerical characters, symbols, and spaces. "public" is set as the
default.
Select whether the LLTD setting is enabled or disabled.
 Enable — Enables the LLTD.
 Disable — Disables the LLTD.
Enter a device name to be displayed on the Network Map.
You can enter up to 16 alphanumerical characters, symbols, and spaces.
Description
Description